removing rear plastic panel

Perhaps someone can shed a little light on the removal of the left rear plastic. I had no trouble takeing the right side off but after removing the same screws on the left side it seems to be stuck. Perhaps since there is a seat lock and a battery in that side there may be other screws or tabs. Please advise before I break something. Thanks

Hi Jim,

Give this thread a try.

https://www.silverwing600.com/t1010-left-rear-cover-removal-pictorial-main-fuse-access

Dennis,

After looking at your pics I was just wondering...How did you keep it so clean. I hardly ever wash mine.

JeffR_ wrote:

Dennis,

After looking at your pics I was just wondering...How did you keep it so clean. I hardly ever wash mine.

Please don't ask bigbird how clean the out side of my Wing was when he put in my sliders. He did say the inside was unusaly clean. sorry didn't mean to hijack

There is one additional screw securing the left panel. That screw faces up on the lower lip of the panel. It's about midway across the width of the panel.

Run your fingers along the lower edge of the panel & you'll feel it.

Jeff,

The darn thing was all most new when I took the pictures. I bet the scooter does not look like that now! I have not owned that bike in all most a year.

Cosmic_Jumper

If you look over my instructions one more time you will see I got that bottom screw written in with a picture when I did the pictorial back in 2009.