Hello I want a way to check conectar cable

Hello I want a way to check conectar cable honda silver wing a scooter ABS 600

Hi abdo3939 and welcome to the forum for all things Silverwing.

The usual way to test the wiring on all vehicles is to use a Multi-meter set as a continuity tester and the manufacturers circuit diagram for tracing the wires your testing.

It would also be helpful to members if you could list the reason why you need to check the wiring as there are several common wiring faults with the Silverwing and your fault could be one of them with an instant answer on how to fix it.

Hope this helps.

Be safe, be seen!

Thank you. I have a scanner and I wanted to check the scooter through the DLC located on the left side.

Hi Again.

From what other members have said in the past the Swings DLC is not an OBDII port but a Honda thing before it became a standard.
I could be wrong though.

Thank you

Like JohnyC mentioned the Silverwing does not have an automotive type standard OBD compatible system or connector port, that can be read with a hand-held scanner, etc.

It does have a fairly easy to use/comprehensive "Self-Diagnostic" procedures in the service manual (providing you are a mechanic or an avid DIYER), for both Fuel Injection (section 5-8 - 5-13 ...) and Brakes/ABS (section 17-0 - 17-4 ....), basically uses a "Jumper Wire" in either system service/check connector, to read or reset memory data and/or determining a current fault, based on indicator number of flashes. Then you go to/follow the page for fault repair procedure flow chart, etc.

By the way, most likely you won't see a fault, unless you have an active "Flashing" light.

Thank you

Hi abdo3939.

here is a link to a Silverwing Maintenance manual should you need.

https://drive.google.com/drive/folders/1cpsqEmvlpa4A4qDPLVGbqlwMfpqnZ0EM