Have someone a picture or can describe me detailed which plug i have to use?
I have the procedure but they only tell very unexactly that i have to connect the tool to a connector with 2 wires (red and green) on the firing pulse generator and i have no idea where this plug is (somewhere behind the right tupperware).

There is a two-wire test terminal as part of the wiring loom behind the left side panel (the panel with the key lock for the seat). That is the same area where the ECU and several relays are located. Hope this helps.

If that doesn't answer your question I'm afraid that you'll have to be a bit more specific about the problem you are trying to fix.

Tim

Left side? My manual said right side...
I try to translate the manual:

Quote:

-remove right side panel -disconnect the two-wire plug from firing pulse generator -connect test adapter to the two-wire plug and then connect it to the battery and do the programmingprocedure (last point shortened by my)

It is easy to locate the correct terminal? I'm a little bit afraid to take the wrong cables and kill my ECU or another very expensive part

OK, i found another mistake by me
Which cable do i have to connect to Battery? Normaly i have to connect a tool, but i don't have it On the firing pulse generator are to cables acc to my manual: Yellow and white/yellow. W/Y is connected to ground, therefore i think i have to connect the battery to the yellow one

OK, my problem is solved.
The first Dealer i asked said i have to make a apointement and it is not so easy.
Now i asked another dealer and he will do it in 10 minutes without a bill. I think it is the best that he will do this job

Gutte gedanken, herr SchwarzeFliege!