ehaughn
Maxi-Scooter Rider
Number of posts: 131
Age: 43
Location: Norcross, GA
Points: 926
Registration date: 2010-06-13
 |  Subject: Givi AF214 Windscreen Torque Advice Needed  Thu Aug 26, 2010 4:56 pm | |
| How tight should the 6 screws securing the windscreen be?
For the original windscreen, Honda recommends 1nm. I have a torque wrench, but only goes down to 5nm.
Thanks
|
|
JeffR
Site Admin
Number of posts: 1672
Age: 52
Location: Fremont, Ca
Points: 2942
Registration date: 2008-12-19
| | Subject: Re: Givi AF214 Windscreen Torque Advice Needed Thu Aug 26, 2010 5:38 pm | |
| I wouldn't worry too much. Just tighten them down good but don't push down since the grommets might fall through the holes and into the fairing. _________________ Ride safe, JeffR 2007 Silver Wing (30,000 miles) 2005 Majesty 400 (sold 12,500 miles) 2004 Reflex (sold 3,500 miles) Givi Windshield, top case, vista cruise, power commander, dr pulley sliders, air hawk seat pad, (J. Costa not installed now), kevlar belt  |
|
bigbird
Silver Wing Guru
Number of posts: 2160
Location: Winnipeg Canada
Points: 3056
Registration date: 2010-05-02
| | Subject: Re: Givi AF214 Windscreen Torque Advice Needed Thu Aug 26, 2010 6:23 pm | |
| | ehaughn wrote: | How tight should the 6 screws securing the windscreen be?
|
Firm but not ham fisted tight. |
|
trouble1100
Maxi-Scooter Rider
Number of posts: 176
Age: 55
Location: Plum Pa
Points: 1011
Registration date: 2010-04-30
| | Subject: Re: Givi AF214 Windscreen Torque Advice Needed Fri Aug 27, 2010 6:39 am | |
| I used German torque on the expandable rubber bushings.
"GUTENTIGHT"
http://neologisms.rice.edu/index.php?a=term&d=1&t=7455 |
|
